Comparing the t46s to the t54w, there were a lot of missing settings beyond the original multicast options that were missing. The two templates have been reconciled with differences and any missing options already available to the t46s that were defined in the t54w have been added.
* Update y000000000067.cfg
Update the Yealink T42S template to add variables for Wifi settings.
* Update y000000000065.cfg
Update the Yealink T48S template to add variables for Wifi settings.
* Update y000000000066.cfg
Update the Yealink T46S template to add variables for Wifi settings.
* Update y000000000068.cfg
Update the Yealink T41S template to add variables for Wifi settings.
* Update y000000000069.cfg
Update the Yealink T27g template to add variables for Wifi settings.
* Update y000000000046.cfg
Update the Yealink T29G template to add variables for Wifi settings.
* Update y000000000028.cfg
Update the Yealink T46G template to add variables for Wifi settings.
* Update y000000000035.cfg
Update the Yealink T48G template to add variables for Wifi settings.
The template for codec enable settings was taking a value as 1 if it was set in the settings. It was not taking the actual value inside it. So I have edited the templates to check the value if it's set to true.
I was having an issue where my T41P phones were getting provisioned with IPv4 & IPv6 - even though I specified in default settings yealink_ip_address_mode=0 for IPv4 only. Checked the y000000000036.cfg, which was setting it correctly. The issue was that {$mac}.cfg was overriding the correct setting. There were several instances of "network.ip_address_mode = 2" in this file, which specifies ipv4&ipv6. I changed all 5 of those entries in this file to pull from the default setting {$yealink_ip_address_mode} rather than just setting a static value of 2. I don't know why it has this listed in this file 5 times. But, this change resolved my issue and will force the T41P provisioning to follow FusionPBX default settings.
Added a line to set SRTP encryption. the default setting yealink_srtp_encryption was not setting properly to my T56a devices. I downloaded my config files and did not find an entry for srtp at all.
compared with the t54w template and it did have a srtp setting. So I pretty much stole the line from the T54w template and dumped it in here.
The T54w template is vastly superior to this one and this probably needs a rewrite to bring it in line.
Tested on my T56a and it at least gets the job done.
frytimo
FusionPBX
frytimo
Mihir Gajjar
wouam31200
Mendel
FusionPBX
Andy Binder
denisent
fusionate
Krushali Shah
Antonio Fernandez
levishores
zrd740
garryavx